Mitsubishi LT2-250 - Feed Dog Height Adjustment

OPERATION FOR AUTOMATIC CORNER STITCHING
6 Stitching procedure
(Standard specification Pedal is deeply heeled
down for corner stitching.)
(1) Shallowly toe down the pedal to lift the presser
foot.
(2) Put fabrics in position.
(3) For start backtacking and double-needle stitching,
toe down the pedal.
(4) Corner stitching is accomplished in the order ~
(5) shown below (stitching isrepeated for the preset
number of steps).
Note: When the present number of steps is com
pleted, the counter Is reset to "V.
(5) When the knee switch is set to "ON", end backtack
ing is done and the threads are trimmed.
(6) When the knee switch is held at "ON", the presser
foot goes up.
(7) Remove the fabrics.
Operation
(1) Neutral
(2) Shallow toe down (inching)
(3) Deep toe down
(4) Shallow heel down (presser foot goes up)
(5) Deep heel down (corner stitching)
Stitching
(j) Start back
tacking and dou
ble needle stitch
ing
@ Single-needle
stitching with
fixed number of
stitches->Pres-
ser foot goes
up.
@ Fabrics are
turned-*Press-
er foot goes
down.
® Single-needle
stitching with
fixed number
of stitches
Double-needle
stitching
End backtack
ing and thread
trimming
Pedal
opera
tion
Stitching
pattern
Pedal toe down
Pedal deeply.
heel down
I I
(D
Continued'
Neutral
Pedal toe down
Knee switch
"ON"
Note: Do not turn off the power during corner stitching.
If the power Is turned off during corner stitching, double-needle stitching may not be resumed by toeing down
the pedal. If the power Is interrupted by mistake, start and continue single-needle stitching as In 3 on the previ
ous page described to resume double-needle stitching.
-11-
From the library of: Superior Sewing Machine & Supply LLC