Mitsubishi LT2-250 - Needle and Feed Dog Motion Alignment (LT2-230)

AUTOMATIC CORNER STITCHING SPECIAL OPERATION PROCEDURE
2 Corner stitching . . . Shallow pedal heeling
operation
(1) The wiring does not differ from that for standard
corner stitching.
(2) The DIP switches "S4L", "S3L", "S2", "S3",
"CKD" and "64P" in the control box should be set
to "ON", as shown in the right figure.
(3) Install the foot switch (option), as shown in the
next figure. The foot switch is used to lift the pres-
ser foot in the middle of stitching.
(4) For corner stitching, perform the following opera
tion in the following order:
Corner stitching . . . Shallow pedal heeling
down
Thread trimming . . Knee switch operation
Presser foot lifting at start of stitching
Knee switch operation or
shallow pedal heeling
Presser foot lifting in the middle of shallow sti
tching
Foot switch operation
Stitching
Pedal
opera
tion
Stitching
pattern
(T) Start back-
tacking and dou
ble needle stitch
ing
Pedal toe down
(2)Single-needle
stitching with
fixed number of
stitches -^Pres
ser foot goes
up.
Pedal shallow,
heel down
I I
0
@ Fabrics are
turned -»• Pres
ser foot goes
down.
Continued -
Neutral
0
Foot switch
@ Single-needle
stitching with
fixed number
of stitches
^ Double-needle
stitching
Pedal toe down
Note: Foot switch (LE-CFT-3) Is optionally available.
-13-
nnnn
(§) Endbacktack-
ing and thread
trimming
Knee switch "ON'
From the library of: Superior Sewing Machine & Supply LLC