Mitsubishi LT2-250 - Wiper Mechanism Adjustment

Item
Trouble
Cause
Remedy
Refer to
P
Single needle operation
occurs through corner
stitching is completed.
Needle select solenoid
does not return to the
original position.
Align the needle select
solenoid.
1 on page 14.
Q
The sewing machine
does not stop with the
needles at UP position,
but goes on running.
Synchronizer is
trouble.
Replace the synchronizer.
8 on page 8.
R
The presser foot does
not goes up after the
needles stop at UP po
sition.
Refer to the description
at item N.
Operation panel is
trouble.
Replace the operation
panel.
S
While number of
stitches and needle
select setting are
changed, corner stitch
ing does not
correspondingly change.
Operation panel is
trouble.
Replace the operation
panel.
T
Pedal heeling down is
heavy.
Pedal switch lever part is
not properly adjusted.
4 on page 18.
-21-
From the library of: Superior Sewing Machine & Supply LLC