3 ETHERNET INTERFACE MODULE REPLACEMENT
3 - 6
3.2.2 Cable specifications comparison
The Q series can use connectable devices (e.g. hubs
*1
, cables, transceivers
*2 *3
) that are being used on
the A/AnS/QnAQnAS series.
For details on connectable devices, refer to the Q Corresponding Ethernet Interface Module User's
Manual (Basic).
*1 When connecting a hub that does not have the auto-negotiation function
On a connection with a hub that does not have the auto-negotiation function,
set the hub side to the half-duplex communication mode.
*2 About wiring of the external power supply terminal (for the transceiver) on the QJ71E71-B5
An FG terminal is not provided for the external power supply terminal on the QJ71E71-B5.
When handling the FG terminal on the external power supply (for the transceiver),
ground the FG signal on the external power supply side.
*3 The shape of the external power supply terminal (for the transceiver) differs between the QnA series QJ71QE71N-B5 and
the Q series QJ71E71-B5. When replacing the AJ71QE71N-B5 with the Q series QJ71E71-B5, refer to the following
manual for wiring.
Q Corresponding Ethernet Interface Module User's Manual (Basic)
To Next Page
Loading...
Need help?
General
