EasyManua.ls Logo

Mitsubishi PAJERO IV - Vehicle Washing

Mitsubishi PAJERO IV
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRECAUTIONS BEFORE SERVICE
GENERAL
0-4
SERVICING THE ELECTRICAL SYSTEM
M6001001000081
CAUTION
Before connecting or disconnecting the negative
(-) cable, be sure to turn off the ignition switch
and the lighting switch. (If this is not done, there
is the possibility of semiconductor parts being
damaged.)
Before replacing a component related to the electri-
cal system and before undertaking any repair proce-
dures involving the electrical system, be sure to first
disconnect the negative (-) cable from the battery in
order to avoid damage caused by short-circuiting.
APPLICATION OF ANTI-CORROSION
AGENTS AND UNDERCOATS
M6001001100022
If oil or grease gets onto the oxygen sensor, it will
cause a drop in the performance of the sensor.
Cover the oxygen sensor with a protective cover
when applying anti-corrosion agents and undercoats.
PRE-INSPECTION CONDITION
M6001001200041
"Pre-inspection condition" refers to the condition that
the vehicle must be in before proper engine inspec
-
tion can be carried out. If you see the words "Set the
vehicle to the pre-inspection condition". In this man
-
ual, it means to set the vehicle to the following condi-
tion.
Engine coolant temperature: 80 to 90° C
Lamps, electric cooling fan and all accessories:
OFF
M/T: Neutral
A/T: P range
VEHICLE WASHING
M6001001300123
If high-pressure car-washing equipment or steam
car-washing equipment is used to wash the vehicle,
be sure to note the following information in order to
avoid damage to plastic components, etc.
Spray nozzle distance: Approximately 40 cm or
more
Spray pressure: 3,900 kPa or less
Spray temperature: 82° C or less
Time of concentrated spray to one point: within
30 sec.
MULTI USE TESTER (M.U.T.-III) SUB
ASSEMBLY
M6001001900169
Refer to the "M.U.T.-III OPERATING INSTRUC-
TIONS" for instructions on handling the M.U.T.-III.
CAUTION
Turn the ignition switch to the LOCK (OFF) posi-
tion before connecting or disconnecting the
M.U.T.-III.
ACX00880
AD
AC300832
AC
Approximately
40 cm or more
AC505420
Diagnosis connector
MB991824
AB
MB991910
MB991827

Table of Contents

Related product manuals