Mitsubishi PAJERO IV - A18. Replace Fuel Filter

OPERATIONS INSIDE THE ENGINE COMPARTMENT
PERIODIC INSPECTION AND MAINTENANCE
2-21
A18. REPLACE FUEL FILTER
M6020201900582
<6G7>
SHORT WHEELBASE
1. Remove the front scuff plate (R.H.) and outer seat
belt (front) anchor bolt (R.H.), and then turn the
floor carpet.
2. Remove the service hole cover.
3. Disconnect the fuel tank pump module assembly
connector, fuel suction hose, fuel high-pressure
tube.
4. Remove the mounting nuts and retainer plate, and
remove the fuel tank pump module assembly from
the service hole.
5. Replace the fuel tank filter assembly and packing
with a new one.
6. Install the fuel tank pump module assembly to the
fuel tank through the service hole.
7. Install the retainer plate to the fuel tank and
tighten the mounting nuts.
8. Connect the fuel tank pump module assembly
connector, fuel tank suction hose, fuel
high-pressure tube.
CAUTION
After connecting the fuel high-pressure tube,
slightly pull it to ensure that it is installed
securely. Also confirm that there is a play
approximately 3 mm.
9. Install the service hole cover.
10.Spread the floor carpet, ant then install the front
scuff plate (R.H.) and outer seat belt (front)
anchor bolt (R.H.).
LONG WHEELBASE
1. Tumble the second seat (R.H.).
2. Remove the service hole cover (upper side).
3. Remove the service hole cover (lower side).
AC609842
AB
Floor carpet
Service hole cover
AC703247
Fuel tank
suction hose
Fuel tank pump module
assembly connector
Fuel high-pressure
tube
AB
AC703246
FUEL PUMP
MODULE
AB
Fuel tank filter
assembly
Fuel tank
pump
assembly
Packing
AC703276
3 mm
Fuel high-pressure tube
Fuel tank pump
module assembly
Quick connector
AB
AC609845
Second seat (R.H.)
Service hole cover
(upper side)
AB
AC609846
Service hole cover
(lower side)
AB