OPERATIONS AFTER ENGINE IS WARMED UP
PERIODIC INSPECTION AND MAINTENANCE
2-39
AUTOMATIC TRANSMISSION FLUID
COOLER LINE FLUSHING
1. Remove the hose shown in the illustration which
allows the A/T fluid to flow from the A/T fluid
cooler to the transmission.
CAUTION
The engine should be stopped within one minute
of it being started. If the A/T fluid has all been dis
-
charged before this, stop the engine at that point.
2. Start the engine and discharge the A/T fluid.
Driving conditions: N range, idling
Discharge amount: Approx. 3.5 L
CAUTION
Stop pouring in the A/T fluid once 3.5 L has been
poured in.
3. Pour in new A/T fluid through the oil filler tube.
Amount to add: Approx. 3.5 L
4. Repeat the operation in step 2 and 3.
NOTE: Carry out steps 2 and 3 so that at least 8.0
L has been discharged from the cooler hose. After
this, discharge a small quantity of A/T fluid and
check for contamination. If the A/T fluid is contam
-
inated, repeat steps 2 and 3.
5. Carry out the procedure in "CHANGE
PROCEDURE" from step 2 onwards.
E3. CHANGE ENGINE OIL
M6020600300637
<6G7>
1. Start the engine and allow it to warm up until the
temperature of the coolant reaches 80
° C to 90° C.
CAUTION
Use care as engine oil could be hot.
2. Remove the engine oil filler cap.
3. Remove the engine oil pan drain plug to drain
engine oil.
4. Install a new engine oil pan drain plug gasket so
that it faces in the direction shown in the
illustration, and then tighten the engine oil pan
drain plug to the specified torque.
Tightening torque: 39 ± 5 N⋅ m
5. Refill with specified quantity of engine oil.
Specified Engine Oil
• ACEA classification: "For service
A1/B1, A3/B3, A3/B4 or A5/B5"
• API classification: "For service SG" or
higher
Total quantity (Includes volume inside oil fil-
ter): 4.9 L
6. Install the engine oil filler cap.
7. Check engine oil level.
<4M4>
1. Start the engine and allow it to warm up until the
temperature of the coolant reaches 80
° C to 90
° C.
CAUTION
Use care as engine oil could be hot.
2. Remove the engine oil filler cap.
3. Remove the drain plug to drain engine oil.
AC607505
AB
AC603625
AD
Engine oil pan
drain plug gasket
Engine
oil pan
side
AC609878
To Next Page
Loading...
