OPERATIONS AFTER ENGINE IS WARMED UP
PERIODIC INSPECTION AND MAINTENANCE
2-41
5. Use the special tool oil filter wrench (MH061590)
to remove the engine oil filter.
6. Clean the filter bracket side mounting surface.
7. Apply a small amount of engine oil to the O-ring of
the new engine oil filter.
Oil filter number:
<4M40> ME013307
<4M41> 1230A046
8. Once the O-ring of the oil filter is touching the
flange, use the special tool (MH061590) to tighten
to the specified torque.
Tightening torque:
<4M40> Approximately 5/8 turn (20 ± 2 N⋅ m)
<4M41> Approximately 3/4 turn (20 ± 2 N⋅ m)
9. Install the engine oil pan drain plug and refill the
engine oil.
10.Race the engine 2− 3 times, and check to be sure
that no engine oil leaks from installation section of
the oil filter.
11.Install the under cover.
E5. CHECK ENGINE IDLING SPEED AND
CO CONCENTRATION
M6020600500545
IDLE SPEED AND MIXTURE CHECK AND
ADJUSTMENT <6G72>
<VEHICLES WITHOUT CATALYTIC CON-
VERTER>
1. Before inspection, set the vehicle to the
pre-inspection condition.
2. Turn the ignition switch to the "LOCK" (OFF)
position and then connect the M.U.T.-III to the
diagnosis connector.
3. Set a timing light to the power supply line
(terminal No. 3) of the ignition coil No. 1.
4. Start the engine and let it run at idle.
5. Check that ignition timing is at the standard value.
Standard value: approximately 10° BTDC
NOTE: The ignition timing may fluctuate within
±
7
°
. This is normal.
AC609883
AB
MH061590
AC609884
AB
O-ring
AC608423
Diagnosis
connector
MB991827
MB991824
MB991910
AC
AK602718
No. 1 Ignition coil
AC
To Next Page
Loading...
