OPERATIONS UNDER THE VEHICLE
PERIODIC INSPECTION AND MAINTENANCE
2-26
2. Check to be sure that the seal and boot of the ball
joint are correctly installed (in the correct
position), and that they are not damaged.
3. Check tie-rod end lock nut for looseness. If lock
nut is loose, adjust toe-in and then tighten lock nut
to the specified torque.
Tightening torque: 93 ± 15 N⋅ m
B6. CHECK GEAR OIL LEVEL IN MANUAL
TRANSMISSION
M6020300600206
1. Remove the filler plug.
2. Check that oil level is up to the lower edge of the
filler plug hole.
3. Check that the oil is not noticeably dirty.
4. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m
B7. CHECK GEAR OIL LEVEL IN
TRANSFER CASE (4WD)
M6020300700236
1. Remove the filler plug.
2. Check that oil level is up to the lower edge of the
filler plug hole.
3. Check that the oil is not noticeably dirty.
4. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m
B8. CHANGE GEAR OIL IN MANUAL
TRANSMISSION
M6020300800244
1. Remove the oil filler plug.
2. Remove the drain plug and drain the oil.
3. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m
4. Fill with specified oil till the level comes to the
lower portion of oil filler plug hole.
Specified transmission oil:
Gear oil API classification GL-4 SAE 75W−
85W
Quantity: 3.2 L
5. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m
AC608838
AB
AC604825
AB
Filler plug hole
Filler plug
Transmission oil
AC604825
AC
Filler plug hole
Filler plug
Transfer oil
AC604827
AB
Drain plug
Filler plug
To Next Page
Loading...
