OTHERS
PERIODIC INSPECTION AND MAINTENANCE
2-48
OTHERS
F1. CHECK BODY CONDITION FOR
DAMAGE
M6020700100254
1. Check underbody coating for damage.
2. Check body painting for damage.
F2. CHECK THE COMMON RAIL ENGINE
(small injection quantity learning)
M6020700400017
LEARNING PROCEDURE
1. After the ignition switch is in "LOCK" (OFF)
position, connect the M.U.T.-III to the diagnosis
connector.
2. Put the vehicle in the following idling stable
conditions:
• Engine coolant temperature: 80 − 90° C
• Automatic transmission fluid temperature: 60° C
or higher
• Lamps, A/C condenser fan and all accessories:
OFF
• Transmission: Neutral <M/T>, "P" range <A/T>
• Power steering: Static state
3. Select SPECIAL FUNCTION from the function
menu.
4. Select SMALL INJECTION QUANTITY
LEARNING from the SPECIAL FUNCTION menu
to execute learning.
CAUTION
• If the vehicle conditions go out of the learning
conditions during idling, learning is inter
-
rupted.
• To reexecute learning, the ignition switch
must once be turned off.
5. Continue idling for about 3 minutes before
learning is completed.
6. Confirm that the engine warning lamp is off. If it
still blinks, reexecute learning.
F3. ROAD TEST
M6020700200325
Drive the vehicle and check for conditions.
1. Check free play of steering wheel.
2. Check efficiency of service brakes and parking
brakes system.
3. Check driveability of engine.
4. Check condition of instruments, gauges
indicators, exterior lamps, heater and ventilators.
5. Check abnormal noise of each part.
6. Check the tyres for wear and for the correct air
pressure.
AC608423
Diagnosis
connector
MB991827
MB991824
MB991910
AC
AC609417
To Previous Page
Loading...
