Mitsubishi QJ71MT91

9 - 19 9 - 19
MELSEC-Q
9 PROGRAMMING
(b) Automatic communication parameters
Set the automatic communication parameters on the [Automatic
communication parameter] screen.
Set the values shown in Section 9.2.1 (2) (b).
(c) MODBUS
®
device assignment parameters
Set the MODBUS
R
device assignment parameters on the [MODBUS(R)
device assignment parameter] screen.
Set the values shown in Section 9.2.1 (2) (c).
POINT
When the MODBUS
R
device assignment parameter screen is displayed, it shows
the initial values. Delete unnecessary initial values.