Mitsubishi QJ71MT91

7 - 2 7 - 2
MELSEC-Q
7 PARAMETER SETTING
(3) Parameter setting procedures
Set the parameters in the following procedures.
YES
NO
2)
Parameter setting procedures
Are the parameters
set using GX
Configurator-MB?
Set the basic parameter starting method
(b0) of the communication condition
setting (Switch 2) to ON (Refer to Section
6.6).
Set the MODBUS device assignment parameter
starting method (b1) of the communication condition
setting (Switch 2) to ON (Refer to Section 6.6).
Set the basic parameters (Refer to
Section 8.7.1, 9.2, 9.3).
Set the automatic communication
parameters (Refer to Section 8.7.2,
9.2, 9.3).
1)
Set the MODBUS device assignment
parameters (Refer to Section 8.7.3,
9.2, 9.3).
R
R
7