Mitutoyo BM1 Series - Appendix; Inspection Report Terminology

27
No. 99MAK004B
6 Appendix
6
Appendix
6
Appendix
■ About the terms used in inspection reports
Nominal size
Maximum dimension
di󰀨erence
Center dimension
Center dimension di󰀨er-
ence
Largest dimension
Minimum dimension
di󰀨erence
Smallest dimension
Range of dimension
di󰀨erences
Tips
In inspection, dimensions are measured at ve points: the center and the four inner
corners (1.5 mm inward from the sides) of the measurement surface of the Gauge
Block.
Measurement
surface