Mitutoyo ID-C0512CNX - About this Document

vi
No. 99MAH056A
About This Document
This document is intended to provide an overview of the product, the functions
of each component, setup, usage and maintenance details.
■How to read this document
53
No. 99MAH056A
5 Setting Parameters
(Short press) / (Long press)
1 Press the [F2] key.
» Calculation function can be set.
2 Setting the execution/stop of the calculation function
1 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch execution/stop.
2 Press the [F2] key.
When execution [on] is selected:
» The calculation function display (A) blinks and the previously set calculation
Tips
When stop [oFF] is selected:
»
(Go to "5.8 Selecting Analog Bar Display" on page 56.)
3
1 Press and hold the [F2] key.
» The sign will blink and can be changed.
» Continue to 3 if not changing the sign.
2 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch the sign.
3 Press the [F2] key.
»
4 Press the [F1] key or [F3] key.
» Each time the key is pressed, the value will change by one.
5 Press the [F2] key.
»
» Each time the key is pressed, the blinking digit moves to the right.
Repeat steps 4 to 5
(e.g.: -6.4641).
»
6
»
(Go to "5.8 Selecting Analog Bar Display" on page 56.)
Indicates an operating
procedure to be performed or
its outline.
Indicates supplementary
information.
Indicates the reference
location.
Indicatesspecicwork
procedures.