Keylltem No. Controlllndicator DescriptionIFunction
The [DATA
OUT]
key is used to output the data
through either the Digimatic Code-Out unit or EIA-232D
output unit. Refer to the Digimatic Code Output Unit
0peration.Manual (No. 02961 5) and the EIA-232D
Output Unit Operation Manual (No. 02961
6) for further
information.
/
This switch turns the ~bwer to the MICROPAK-2LA ON
or
-OFF.
The [ENTER] key is used to enter preset data and
memory locations for storing or recalling data.
(.
.
-:
29
NUMERIC
KEYPAD
The numeric keypad is used to select preset or memory
location data using the number keys
[Ol
through
t91.
Pressing this key alternates the polarity of the selected
data between positive and negative. This key may be
used at
any time during the data selection. until the data
is entered.
To Next Page
Loading...