MIXER PLUS Series - Page 30

Manual instruction Mixer Plus Mixer Technology srl pag.30
NR
ANOMALIES
CAUSES
SOLUTIONS
4) stator/rotor
assembly tear.
1c) verify that the insertion of
the outlet in the electric plug of
the gearmotor;
1d) insert the power supply
plug;
2) insert the mixer;
3) reduce the water flow arte
indicated on the flow meter
acting on the adjustment valve;
4) replace the assembly stator
rotor.
7
The compressor
stops – thermal
protection
tripping
1) mechanical break
of the compressor
(with rod
malfunction);
2) clogged suction
filters;
3) cable or plug
damaged.
1) visible from outside (request
technical assistance);
2) replace the filters;
3) check cable and plug and
replace, if necessary.
8
The water pump
stops - thermal
protection
tripping
1) pump blocked;
2) cables and plug
damaged.
1) perform the reset of the
thermal protection tripping (if
necessary, request technical
assistance);
2) check the cable and the plug
and, if necessary, replace the
damaged parts.
9
The mixture
comes out from
the spraying
nozzle too liquid.
1) excessive water
flow rate;
2) mixture scaling on
the mixer;
3) obstruction of the
material output
connection.
1) reduce the water flow rate
acting slowly on the water
adjustment valve;
2) clean the mixer;
3) clean the material output
connection.
10
The mixture
comes out from
the spraying
nozzle too dense.
1) poor water
quantity;
2) mixer dirty;
3 mixing chamber
dirty.
1) increase the water flow rate
acting slowly on the water
adjustment valve;
2) clean the mixer;
3) clean the mixing chamber.