MIXER PLUS Series - Spraying Material; Machine Switching Off

Manual instruction Mixer Plus Mixer Technology srl pag.25
SPRAYING OF THE MATERIAL
1) Hold the spraying nozzle and direct it against the surface to be plastered;
2) Open (+) the valve on the spraying nozzle;
3) Adjust the spraying of the material moving forwards and/or backwards (+ or -),
the air tube acting on the screw and blocking it in the correct position;
4) To minimize the deterioration of stator/rotor group, avoid useless stops and
restarts of spray;
5) During work breaks less than 15 minutes, close the valve on the spraying
nozzle. For longer breaks must be execute the shutdown process;
6) In case of clogged of material conveying tube, enabling the mixer reverse run
selector for the time needed;
MACHINE SWITCHING OFF
1) Stop the cell wheel;
2) Continuing the spraying till from the spraying nozzle just water;
3) Closing the valve on the spraying nozzle;
4) Stop the mixing chamber;
5) After every shutdown, carry out the machine cleaning;