15
Audio Tab
When checked, this option gives an initial panning value to sounds as they are
loaded in the Remixing Studio. The panning values given are based on a sound’s
relative position in a turntable. When unchecked, all sounds are panned in the
center as they are loaded.
Long Release
When checked, any sounds that are playing when a Mix is stopped continue to
play until they fade out naturally. When unchecked, all sounds stop immediately
when the mix is stopped.
Real-time Pitch Changes
DM2 has two ways of handling pitch changes in the Remixing Studio. The default
is to change the pitch in real time. The other option is to make all the pitch
change settings on any number of tracks and then press the Tab key to engage
the result of the pitch changes. This is a technique more familiar to those who
used earlier versions of Mixman software.
Tempo Changes Wave Pitch
If you select this option, then changing tempo will change the pitch of loaded
Wav files.
Enable W.A.R.P.
The W.A.R.P. feature is one of the demanding features on the computer’s CPU.
Prior to the fast machines that are now prevalent, we included this option for
people who were on slower computer systems. By disabling W.A.R.P., DM2 has
smoother performance on a slower system. Most users on a fast, current
computer should not need this option.
Loop Mixes
This is a simple feature that allows any mix to keep playing over and over in the
Remixing Studio.
Display Tab
There are several different settings available. You may disable Bubble Help or
Track Name display when rolling over a track or object in any studio.
Other settings on this tab are included to enhance performance on low-end
computers only. These settings should not be adjusted without directions from
technical support.
Sound Card Tab
This option enables you to make changes in the overall system performance.
These settings should not be changed unless you are having performance
problems with your DM2. Please see the Troubleshooting section for specific
setting instructions.
To Next Page
Loading...