Page 6 of 46
WARNING: Do not submerge the EVA Pro handle, battery charger, or battery in
fluid of any type. It may short the electronics and cause an electrical shock to the
user.
REQUIRED EQUIPMENT
Before using the EVA Pro, the following equipment should be accessible:
● Battery pre-charged. Full charge is recommended but not required.
HANDLING AND PREPARATION
Inspection Before Each Use
Before each use, perform the following:
General Inspection
● Inspect for visible damage to the EVA Pro handle, battery, and all
connections.
● Make sure that no parts are missing or loose.
● Make sure that connecting elements between instruments function
properly.
●
Verify that the EVA Pro and accessories
are in good working order by following
the “Activating the Unit” steps outlined
in the following section.
●
If the battery is not already installed,
insert a charged battery into the handle
of the unit. The battery can only be
inserted in a single
the battery into place until the locking
tabs snap; these tabs lock the battery
into the handle.
WARNING: Examine all accessories and connections to the EVA Pro before use.
Ensure that the accessories function as intended. Improper connection may
result in accessory malfunction.
NOTE: The battery is removed by compressing the two locking tabs on the sides
near the battery base releasing the lock and, while firmly holding the unit head,
pulling the battery down and out of the handle.
Figure 3: EVA Pro Battery
To Next Page
Loading...
