Error in time information (align with
autoclave).
Difference of temperature over the limit
between Pt1 (regulation probe) and Pt2
(control probe) during washing phase
TEMPERATURE ABOVE
MAX LIMIT
Temperature PT1 over the limit
permitted for washing phase.
TEMPERATURE BELOW
MIN LIMIT
Temperature PT1 below the permitted
value for the washing phase
Anomalous reduction of water level
during washing phase.
Anomalous increase of water level
during washing phase.
Anomalous reduction of water level
during disinfection phase.
Anomalous increase of water level
during disinfection phase.
Difference of temperature above the
limit between Pt1 (regulation probe)
and Pt2 (control probe) during thermal
disinfection phase.
TEMPERATURE ABOVE
MAX LIMIT
Temperature PT1 over the limit
permitted for thermal disinfection
phase.
TEMPERATURE BELOW
MIN LIMIT
Temperature PT1 under the limit
permitted for thermal disinfection
phase.
DETERGENT FLUID
DOSING DEVICE
PROBLEM
Excessive detergent dosing time.
US - COMMUNICATION
INTERRUPTED
Ultrasounds switching off because of a
temporary lack of communication.
US – SONOTRODE
DISCONNECTED
Malfunction of one or more sonotrodes
of the ultrasound system
Excess of current in the ultrasound
system
Lack of tuning in the ultrasound system
No communication between control
board and ultrasound board
3 (in cycle)
2 (stand-
by)
Low power of ultrasounds during
washing phase.
Ultrasound board software CRC check
failed
3 (in cycle)
2 (stand-
by)
1 = OK (warning) + chamber emptying
2 = OK (warning)
3 = cycle interruption + ok + door unlock + reset 3
To Next Page
Loading...
