108
Display Operating Procedure
Description
“Technical” Programming
Enter Password
1
After accessing the “Technical” programming menu and entering the password, use the buttons T1 and T2
until the following screen is displayed.
Update Firmware
2
Press the T3 button to enter the menu.
Insert USB Key
And Press Enter
3
Insert the USB Pendrive into the USB port and press the T3 button .
OFF 00:00
4
When the update is over, the espresso machine restarts. Set the switch to 0 (zero) and then again to 1.
• This parameter allows the technician to
update the control unit of the espresso
machine via a USB Pendrive.
Update Firmware
Enter Password
Update Firmware
To Next Page
