modbar av Series - Page 53

EN
53
Display
Operating Procedure
Description
“Barista” Programming
(only on ABR espresso machine models)
G1█ MODBAR G2█
163Puls 0Puls
1
When the espresso machine is turned on, press and hold the T3 button to access the “Barista” programming.
After about 5 seconds the following screen is displayed.
Group Dose
Settings
2
Move between the parameters using the buttons T1 or T2 until the display shows:
Group 1 Dose
Settings
3
Press the T3 button to start the doses programming procedure.
G1 Dose Mode
BREWRATIO
4
Press the T3 button to access the menu, then navigate using T1 and T2 to choose between PULSES,
MASS and BREWRATIO, press the T3 button to conrm the option.
• This parameter allows the operator to
program the amount of coffee (brewing
amount) for each Selection Indicator.
• The brewing amount can be set in terms
of time (sec.), pulses, mass or brewratio.
• Once programmed, the Selection
Indicator remains lighted.
• It is possible to set the dose for both
a short and a long shot on the same
Selection Indicator.
• PULSE mode: control of doses in volume
• MASS mode: control of doses in mass
• BREW RATIO mode: ratio between the
coffee powder and the weight of the
drink
Program Dose
Group Dose
Settings
Group 1 Dose
Settings