modbar av Series - Page 54

EN
54
Display Operating Procedure
Description
“Barista” Programming
(only on ABR espresso machine models)
G1 ↑ Brew Ratio
1:2.0 0
5
Press the button T1 or T2 to view the dose of each key. Pressing the button T3 , the dose value will
blink. Use the button T1
or T2 to change the value, press the button T3 to conrm the desired value.
G1 ↑ Long
Weigh Coffee
6
Press the button T1 or T2 to view the coffee mass of each group. Pressing the button T3 , the value will
blink. Use the button T1
or T2 to change the value, press the button T3 to conrm the desired value.
G1 ↓ Long
WEIGH PF
7
Press the button T1 or T2 to view the portalter mass of each group. Pressing the button T3 , the value
will blink. Use the button T1
or T2 to change the value, press the button T3 to conrm the desired
value.
G1 PF Mass
800.0g
8
Press the button T1 or T2 to view the portalter mass of each group. Pressing the button T3 , the value
will blink. Use the button T1
or T2 to change the value, press the button T3 to conrm the desired
value.
• This parameter allows the operator to
program the amount of coffee (brewing
amount) for each Selection Indicator.
• The brewing amount can be set in terms
of time (sec.), pulses, mass or brewratio.
• Once programmed, the Selection
Indicator remains lighted.
• It is possible to set the dose for both
a short and a long shot on the same
Selection Indicator.
• PULSE mode: control of doses in volume
• MASS mode: control of doses in mass
• BREW RATIO mode: ratio between the
coffee powder and the weight of the
drink
Program Dose
Group Dose
Settings
Group 1 Dose
Settings