modbar av Series - Page 55

EN
55
Display
Operating Procedure
Description
“Barista” Programming
(only on ABR espresso machine models)
G1 Coffee Mass
14.0g
9
Press the button T1 or T2 to view the coffee mass of each group. Pressing the button T3 , the value will
blink. Use the button T1
or T2 to change the value, press the button T3 to conrm the desired value.
E xit
Group 1
10
Press T1 or T2 until the display shows the exit menu, press the T3 button to return to the “Barista”
programming.
11
Press T1 or T2 to continue with the programming of the other parameters.
G1█ MODBAR G2█
163Puls 0Puls
12
Press T2 and T3 at the same time to exit the programming mode and return to the normal use of the
espresso machine.
• This parameter allows the operator to
program the amount of coffee (brewing
amount) for each Selection Indicator.
• The brewing amount can be set in terms
of time (sec.), pulses, mass or brewratio.
• Once programmed, the Selection
Indicator remains lighted.
• It is possible to set the dose for both
a short and a long shot on the same
Selection Indicator.
• PULSE mode: control of doses in volume
• MASS mode: control of doses in mass
• BREW RATIO mode: ratio between the
coffee powder and the weight of the
drink
Program Dose
Group Dose
Settings
Group 1 Dose
Settings