modbar av Series - Page 60

EN
60
Display Operating Procedure
Description
“Barista” Programming
Group Dose
Settings
Pre-Inf
Settings
• This parameter allows the operator to
program the time of pre-brewing of
water with the coffee. Each group can
have a different programming.
• Pre-brewing has only two values to be
adjusted for each group. The time (in
seconds) for which the brewing valve
is open during the pre-brewing cycle
and the time (in seconds) for which
the brewing valve is closed during the
pre-brewing cycle; during this time the
pump is active. Once the pre-brewing
cycle is over, the normal brewing cycle
will continue until the end.
• For an espresso machine composed of
two groups, they are identied as Group
1 and Group 2.
Pre-Infusion or Pre-Brewing
G1█ MODBAR G2█
163Puls 0Puls
1
When the espresso machine is turned on, press and hold the T3 button to access the “Barista” programming.
After about 5 seconds the following screen is displayed.
Group Dose
Settings
2
Move between the parameters using the buttons T1 or T2 until the display shows:
Pre-Inf
Settings
3
Press the T3 button to enter the menu.
Group 1 Pre-Inf
2s Wet 0s Hold
4
Press T1 or T2 to select the group whose parameters you want to set.
By pressing the T3 button
the rst value will blink. Use the buttons T1 and T2 to reach the value
that you want to set, press T3 to conrm. Repeat this operation to set the second value.
To set the preinfusion time 2 seconds minimum.