modway Adept EEI-3061 User Manual

EEI-3061 BENCH
Customer Service 908-368-1025︱www.modway.com
Page 1 of 4
Thank you for purchasing the MODWAY BENCH.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
A. Bolt M8x 65mm x 8
B. Bolt M8x 45mm x 4
C. Spring Washer x 12
D. Flat Washer x 12
E. Allen Wrench x1
Components:
1 Bench Body x1 2 Leg x 2 3 Leg stretcher x 4 4 Leg x2

modway Adept EEI-3061 Specifications

General

Category	Indoor Furnishing
Product Type	Chair
Style	Modern
Color	Black
Product Name	Modway Adept Performance Velvet Swivel Office Chair - EEI-3061

Summary

Bench Assembly Instructions

Step 1: Prepare Bench and Components

Place bench body on a padded surface and unpack legs and hardware from the bottom zipper.

Step 2: Attach First Leg

Attach a leg to the bench body using bolts, spring washers, and flat washers, then tighten with Allen wrench.

Step 3: Attach Leg Stretchers

Insert leg stretchers into legs and attach to the bench body using bolts, spring washers, and flat washers.

Step 4: Attach Remaining Legs

Repeat steps to attach remaining legs and leg stretchers to the bench body in the correct positions.

Step 5: Finalize Assembly

Close the zipper on the bench bottom and carefully turn the assembled bench upright.