Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI –2700 DINING CHAIR
STEP 3:
Assembly is complete. Your chair
is ready to be used now!
Carefully turn over the assembled Chair Back (1), Chair Seat (2), Left Frame (3) and Right Frame (4).
Insert 2 pieces of Bolt (A) into the pre-drilled hoes on Chair Back (1) through the top pre-drilled holes on Left Frame (3).
Insert 2 pieces of Bolt (A) into the pre-drilled hoes on Chair Seat (2) through the top pre-drilled holes on Left Frame (3) .
Use Allen Wrench (B) to tighten Bolts (A) clockwise until secure.
Repeat the same steps for Right Frame (4).
Hardware & Tool required
Ax8 Bx1
Carefully position the assembled chair to the desired location.
Put Seat Cushion (5) into the assembled chair .
Tie Seat Cushion (5) to Chair Back (1) by using the banding on the back of Seat Cushion (5) as shown.
STEP 4:
A
A
A
A
1
3
A
B
5
A
4
2
A
Banding on the back of seat cushion
To Previous Page
Loading...
