Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 4
EEI –2852
DESK
STEP 1:
STEP 2:
Put Top Frame (A) upside down on a carpeted or padded surface.
Place 4 pieces of Leg (B) to Top Frame (A) as shown.
Insert 8 pieces of Short Bolt I (1) into the pre-drilled holes on Top Frame (A) through the pre-drilled holes on Legs (B).
Use Allen Wrench (6) to tighten Short Bolts I (1). Do not fully tighten Short Bolts I (1) at this step.
Hardware & Tools required
Hardware & Tools required
1x8 6x1
3
B
1x4 6x1
2x4
4x4
Put Bottom Rails (E) and Back Rail (D) to the assembled Top Frame (A) and Legs (B) as shown.
Insert 4 pieces of Long Bolt (2) into the pre-drilled holes on Back Rail (D) through the pre-drilled holes on Bottom Rail (E).
Insert 4 pieces of Medium Bolt (4) into the pre-drilled holes on Side Rails (E) and Back Rail (D) through the pre-drilled holes
on Legs (B).
Insert 4 pieces of Short Bolt I (1) into the pre-drilled holes on Side Rails (E) and Back Rail (D) through the pre-drilled holes
on Legs (B).
Use Allen Wrench (6) to tighten all the Bolts (1&2&4). Do not fully tighten all the Bolts (1&2&4) at this step.
E
D
B
2
B
B
B
B
2
C
C
6
1 1
1
1
1
1
1
1
A
B
B
B
B
E
D
E
E
D
4
1
2
2
4
1
1
2
2
6
2
1
4
1
4
A
4
To Next Page
Loading...
