13
10/04 AWB2528-1548GB
2 Installation
The MFD-CP4 must only be installed and connected up by
trained electricians or a person familiar with the installation
of electrical equipment.
The MFD-CP4 is installed in the following order:
• Mounting,
• Connecting the serial interface,
• Connecting the power supply.
Mounting Install the display/operator unit in the front of a control
cabinet, a service distribution board, operator panel or in an
enclosure. You can protect the display/operator unit with a
protective membrane or cover, depending on the
environment in which it is to be used. This must be fitted
before the MFD-CP4 is mounted and is therefore described
in the next section.
The MFD-CP4 power supply/communication module must be
mounted in such a way that all the terminals are protected
against direct contact, liquids and dust during operation.
For sufficient heat circulation around the device, the rear of
the MFD-CP4 and the terminals must have a clearance of at
least 3 cm from the wall or adjacent devices.
To Next Page
Loading...