5
10/04 AWB2528-1548GB
1 About the Display/Operator
System
Target readership The MFD-CP4 must only be installed and connected up by
trained electricians or persons familiar with the installation
of electrical equipment.
A specialist knowledge of electrical engineering is needed
for commissioning. When controlling active components
such as motors or pressure cylinders, parts of the system can
be damaged and persons put at risk if the MFD-CP4 is
connected or programmed incorrectly.
Proper use The MFD-CP4 must be properly installed before use.
• The MFD-80/MFD-80-B display and operator unit is
protected to IP65 and does not normally require any
special housing protection.
• The rear of the MFD-CP4 unit is designed as a mounting
unit and must be installed in an enclosure, control cabinet
or a service distribution board.
• The installation must comply with regulations for
electromagnetic compatibility (EMC).
• The power up of the MFD-CP4 must not cause any hazards
arising from activated devices, such as unexpected motor
startups or power ups.
To Next Page
Loading...