Graphic mode on the remotely
operated device
33
10/04 AWB2528-1548GB
Connection faulty If the connection is faulty or interrupted, the MFD-CP4 will
display the message “Connection establishment in
progress...” continuously. This message may, however, also
be due to an incorrect COM setting (a section “Main
menu”, page 11).
Graphic mode on the
remotely operated device
If the display/operator system is connected with another
MFD device which is in Graphic mode, this graphic will not
be shown by the display/operator system. You can terminate
graphic mode from the display/operator system by pressing
ALT + ESC. The same thing can be achieved by pressing the
“*” button on the remotely operated MFD device as long
another function was not assigned to this button
(a section “Special function”, page 12).
Connection
establishment
in progress...
To Next Page
Loading...