Moeller MFD-CP4 - Connection faulty; Graphic mode on the remotely operated device

29
10/04 AWB2528-1548GB
3 Commissioning
Switching on Before switching on check that the power supply and the
connection cable are properly connected:
– Terminal +24 V: voltage +24 V
– Terminal 0 V: voltage 0 V
If you have already integrated devices into a system, secure
any parts of the system connected to the working area to
prevent access and ensure that no-one can be injured if, for
example, motors start up unexpectedly.
Caution!
The MFD-CP4 allows you to operate a device that may be
positioned far from your actual location. All access rights
that you would also require "locally" are granted to you.
It is not always possible to obtain a view of the situation
“locally”. Use of this operating mode and the execution of
any changes to device settings should only be carried out
with the utmost caution.
You can also carry out settings locally on the device whilst
you are operating a device remotely via the keypad. In this
case, the local operation on the device is always faster
than the remote operation in Terminal mode. Bear in mind
that this may lead to conflicts that may trigger faults or
unforeseen events.
h
A MFD-CP4 makes its display and operator unit available
to the connected device. Only data for the display and the
status of the buttons is sent via the connection. This
ensures that the local data of the connected device is not
destroyed in the event of a communication fault.