14
FLYWHEEL BEARING
The bearings in the flywheel are lifetime greased and
require normally no maintenance. If problem arises,
please contact your Monark dealer.
REPLACEMENT OF SENSOR
Remove the left cover as described on page 12.
Divide the cable at the joint cabel.
Loosen the screw for the sensor. See fig 23.
Replace the sensor with electric cable and assemble
again to the above but in reverse order.
Fig 23
Electric cable
Frame
Handwheel with
tension screw
Handlebar stem
Electronic meter
Joint contact
Sensor
Screw
To Next Page
Loading...
