FG038 MK2 Divider RevA19 13-02-19 19
8.0 WEEKLY CLEANING INSTRUCTIONS
WARNING:
Internal parts can still move causing injury,
even if machine is turned off and isolated.
WARNING:
CLEANING SHOULD ONLY BE CARRIED OUT BY FULLY TRAINED PERSONNEL
NOTE:
ISOLATE MACHINE FROM MAINS SUPPLY
1 Remove four screws (22), two each side.
2 Remove side sheets (23) and (24).
3 Remove top covers (7) and (12).
4 Remove, clean and refit suction piston
drip tray (26).
5 Remove, clean and refit guard sheet (27).
6 Clean out oil way (28) and wipe down all
interior bright work.
7 Brush down interior framework with nylon
bench brush.
8. Clean down interior framework with a solution
of hot water and sterilising solution, taking care
not to get excessive water into the machine.
Take special care around the motor and housing.
9. Scrub wheels with small nylon cleaning brush
or scouring pad and hot water sterilising solution.
10 Refit side sheets, covers and screws.
11 Clean entire exterior surfaces of the machine
working from top to bottom.
12 Remove and clean oil collection tank (17) and
drip tray (18).
To Next Page
Loading...
Need help?
General