FG038 MK2 Divider RevA19 13-02-19 25
Dough Pieces of less than 450g.
Normally, actuating pin (11) should be located in saddle notch (1lb+) 450g. However,
when producing dough pieces of less than 1lb (450g) weight it is preferable to change
the notch setting to avoid excessive pressure being put on the dough:
To change notch:
1 Cycle machine to position 'i' of dividing cycle.
2 Lift cover (7).
3 Withdraw locking pin (8) and remove actuating pin (9) from knife arm (41).
4 Remove knife (25).
To Next Page
Loading...
Need help?
General