FG038 MK2 Divider RevA19 13-02-19 26
5 Lift saddle (22), pull back piston, and lower saddle notch (1lb-) onto suction
piston actuating pin (9).
6 Refit knife (25).
7 Refit cover (7).
ADJUSTING MOULDING PRESSURE
Offtake pressure board (19) may be raised or lowered by means of adjusting handle
(20) with spring loaded plunger. As a guideline, the second detent from the top is
generally suitable for 900g range dough pieces and the fourth from the top for 450g
range dough pieces.
NOTE: When used with intermediate prover the pressure board must be set correctly
or prover infeed system may malfunction causing loss of dough.
To Next Page
Loading...