Monoprice Maker Ultimate 2 - Machine Tab; Line Width Tab

28
Machine Tab
 Right Nozzle Diameter (mm): Sets the diameter of the nozzle on the right extruder.
This printer only has a single extruder, which is designated the right extruder. The
nozzle diameter of this printer is 0.4mm.
 Left Nozzle Diameter (mm): Sets the diameter of the nozzle on the left extruder.
This printer only has a single extruder, which is designated the right extruder.
Line Width Tab
 Outer Wall Line Width (mm): This is the width of the outermost wall line. By
lowering this value, higher levels of detail can be printed.
 Inner Wall(s) Line Width (mm): This is the width of a single wall line for all walls
except the outermost wall.
 Top/Bottom Line Width (mm): This is the width of the top and bottom lines.
 Infill Line Width (mm): This is the width of a single infill line.
 Support Line Width (mm): This is the width of a single support structure line.
 Skirt/Brim Line Width (mm): This is the width of a single skirt or brim line.