45
Seam, because the filament continues to ooze at the start/stop location. The options on
this screen are used to mitigate this effect.
• Z Seam Type: Determines where the Z Seam will appear.
• Shortest: This option selects the most time efficient start/stop location.
• User Specified: This option allows you to specify the X and Y start/stop location,
which determines where the Z Seam will appear.
• Random: With this option, the printer will randomly choose the start/stop
location, which prevents building a column.
• Sharpest Corner: The start/stop location and the Z Seam will appear in the
sharpest corner of the model.
• Z Seam X (mm): This option is the X location of the Z Seam. This option can only be
set when the Z Seam Type is set to User Defined.
• Z Seam Y (mm): This option is the Y location of the Z Seam. This option can only be
set when the Z Seam Type is set to User Defined.
• Hiding Seam Preference: This option is only available when the Z Seam Type is set
to Sharpest Corner. It determines whether the Z Seam will be on the inside or
outside of the corner.
• Z Seam Relative: Checking this box will set the Z Seam in respect to the object's
center, whereas leaving the box unchecked will set the Z Seam along the absolute
position on the build plate. This option is only available when the Z Seam Type is set
to User Defined.
To Next Page
