One-Net/DASDEC User Manual 2-7v3.0 | r0616
POWER CONNECTIONS
Once all connecons are completed, power can then be applied to the device. A panel-
mounted IEC compliant AC power receptacle, found in the lower le corner of the
device’s back panel (19), delivers power to the internal AC power supply. Use only an
approved IEC 320 C-13 type line cord rated for a minimum 10A at 250V. A power cord is
supplied with your EAS device. Connect the cable’s female IEC connector to the power
receptacle on the frame, and connect the three-prong male connector to an AC outlet.
Press the Power rocker switch (5) to iniate the start up sequence. Pressing this buon
a second me will iniate the shut down sequence.
Warning
The safe operaon of
this product requires
that a protecve earth
connecon be provided.
This is provided by the
grounding conductor in
the equipment’s supply
cord. To reduce the risk
of electrical shock to
operator and service
personnel, this ground
conductor must be con-
nected to an earthed
ground.
To Next Page
Loading...