SECTION Vlll
MOONEY
HANDLING,
SERVICE
&
6flAIIVTENANCE
MODEL
M20J
AND APPLICATION CLQTHS
BE
FREE
OF
ABRASIVES, GRIT,
OR
OTHER
FOREIGN MATTER.
Use a prewax cleaner to remove a heavy oxidation film.
For nonoxidized or
precieaned surfaces, apply a good exterior finish wax
recommended for protection of urethane enamel finishes. Carefully follow the
manufacturer's instructions.
A
heavier coating of wax on the leading edge of
the wings, empennage, and nose section
vvill help redlice drzg and abrasior
in these areas.
If fuel, hydraulic fluid, or any
other dye-containing substance is found on the
exterior paint, wash the area at once to prevent staining. Immediately flush
away spilled battery acid, and treat the area with a baking soda and water
solution, followed by a thorough washing with a mild aircraft detergent and
warm water.
Before wiping the windows or windshield, flush the exterior
with clear water to
remove particles of dirt. Household window cleaning compounds should not
be
l~sed
as
sorne contain abrasives or solvents which could harm plexiglas.
An
anti-static plexiglas cleaner is good for cleaning and polishing the
windshield and windows.
lNTEWlOR CARE
Norma! household cleaning practices are recommended for routine interior
care Frequently
vacuum cleats the seats, rugs, upholstery panels, and head
liner to remove as much surface dust and dirt as possible Qccasionaliy wat
the leather or vinyl upholstery and kick panels with a mild soap solution
to
prevent dirt from working into the surface Wiue clean with a slightly damp
clotll and dry with a soft cloth. NEVER APPLY FURNITURE POLISHES.
Foam-type shampoos and cleaners for vinyl, leather, textiles, and plastic
materials are good for removing stains and reconditioning the entire interior.
Spray dry cleaners are also recommended Grease spots on fabric should
be removed with a jelly-type spot lifter
MNNNNNNNM
"
CAUTION
"
NNNNNNNNN
Never use denatured alcohol, benzene, carbon tetrachforide,
acetone, or gasoline for cleaning plexiglas or interior plastics.
Carefully
lollow the manufacturer's instructions when using
commercial cleaning and
linishiug compounds.
Do not saturate
fabrics with a solvent which could damage
the backing and padding materials. Yo minimize carpea
wetting, keep foam type cleaners
as
dry
as
possible and
gently rub
in circles. Use a vacuum cleaner %o remove
foam
and to dry the materials.
Use a damp cloth or a mild soap solution to clean interior plastic, vinyl trim
and metal surfaces.
REV.B
6-1
2-87
ISSUED
6-2-86
To Next Page
Loading...
