LIN ENGINEERING Page 3 Version 6.70
R701P User Manual 02/15/2022
Thank you for purchasing the R701P Driver. This product is warranted to be free of
manufacturing defects for one year from the date of purchase.
Technical Support
By Telephone: 408-919-0200
(Mon.-Fri., 8:00 a.m.-5:00 p.m.)
By Email: techsupport@linengineering.com
Our technical support group is glad to work with you in answering your questions. If you
cannot find the solution to your particular application, or, if for any reason you need
additional technical assistance.
PLEASE READ BEFORE USING
Before you start, you must have a suitable step motor, a DC power supply suitable for the motor and
an optional current resistor. The motor’s rated phase current must be between 0.8 Amps and 7 Amps
when using the dip switches, or between 0 Amps to 7 Amps when using the current resistor. The
power supply voltage must be between 4 times and 20 times the motor’s rated voltage. The current
set resistor may be a ¼ Watt, 5% part. Finally have a STEP and DIRECTION pulse source available.
DISCLAIMER
The information provided in this document is believed to be reliable. However, no responsibility is
assumed for any possible inaccuracies or omissions. Specifications are subject to change without
notice.
Lin Engineering reserves the right to make changes without further notice to any products herein to
improve reliability, function, or design. Lin Engineering does not assume any liability arising out of the
application or use of any product or circuit described herein; neither does it convey any license under
its patent rights, nor the rights of others.
Special Symbols
The “exclamation mark” indicates a WARNING and that this information could prevent
injury, loss of property, or even death (in extreme cases).
To Next Page
Loading...
