Moons' MC Series - Page 10

MC Series Brushless Driver User Manual
9
2023 - September version V1.2
Motor feedback
Digital Hall supports up to 2.5 kHz switching frequency and 5 V logic level
Incremental encoder supports up to 16384 resolution
Motor interface
Brushless Motor
U, V, W three-phase winding
Status Display
Standby
Green light is always on
run
Green light flashing
Fault
red light
Failure
protection
Stall alarm
The motor is blocked for more than 2 seconds and the motor is
disabled.
Current limit value
If the current exceeds 15A or the set value, the system
automatically reduces PWM to reduce the current. If the
current still exceeds the limit after the duty cycle is reduced to
the minimum value, the driver alarms and stops working.
Overcurrent alarm
value
If the current exceeds the set current, the motor will be
disabled and an alarm will be issued.
Overpressure
Alarm when the working voltage is >55V, and restore when the
voltage drops to 50V
Undervoltage
Alarm when the working voltage is less than 9.5V, and restore
when the voltage rises to 12V
Hall sensor alarm
The Hall sensor signal is lost or abnormal for 100ms and then
an alarm is issued
Size
weight
254 g
size
120x76x24.5mm (excluding connectors)
Environmental
conditions
Operating ambient
temperature range
-30℃—45℃
environment
humidity
5% - 90% (no condensation)
Use occasions
Avoid dust, oil mist and corrosive gas
save
-40℃—85℃