MC Series Brushless Driver User Manual
23
2023 - September version V1.2
3.3 Port Wiring
EN : Connect EN to the driver GND, with a switch /relay in between . The switch /relay can be used
to control whether the motor is enabled or disabled.
When the switch is closed, EN and GND are connected and the motor is enabled.
When the switch is disconnected, EN is suspended, and there is a pull-up resistor inside EN to pull
the level up. At this time, it is a high level and the motor is not enabled.
The wiring is as shown below:
Figure 7 Enable port wiring diagram
FR: Connect FR to the GND power supply of the driver, and connect a switch /relay in the middle .
The switch /relay can control the forward/reverse rotation of the motor
When the switch is closed, FR is connected to GND and the motor rotates clockwise.
When the switch is disconnected, FR is suspended, and there is a pull-up resistor inside FR to pull
the level up. At this time, it is a high level and the motor rotates counterclockwise.
The wiring diagram is as follows:
Figure 8 Steering port wiring diagram
To Next Page
Loading...
