MC Series Brushless Driver User Manual
22
2023 - September version V1.2
Optional accessories (sold separately)
UART communication line
The driver and the host computer use UART serial port communication, and the wiring
harness uses USB to TTL wiring harness.
When communicating, connect the corresponding interface end of the harness to the driver's
TX , RX , and GND ports , and plug the USB port into the computer.
USB to serial port cable provided by our company , and its pinout is defined as follows:
Note: Please close the serial port in the host computer software before unplugging the
harness. Do not unplug the harness directly, otherwise hot plugging may easily cause damage
to the harness.
To Next Page
Loading...
