Moons' MC Series - Page 16

MC Series Brushless Driver User Manual
15
2023 - September version V1.2
J3 Hall sensor interface:
sequence of this interface corresponds to the three-phase line of the motor one by one . When using
the Hall-free mode , this interface does not need to be connected.
Pinout
Signal
definition
1
HU
U phase Hall input
2
HV
V phase Hall input
3
HW
W phase Hall input
4
+5V
Hall power supply
5
GND
Hall power supply ground
Pluggable terminal block 5 pins suitable for 0.14~0.15 mm² cable or AWG 28-16 cable
J4 analog I/O port:
The main function of this interface is external voltage speed regulation and feedback speed signal.
Pinout
Signal
definition
1
ANOUT
Analog output signal
2
GND
Voltage speed control signal
reference ground
3
ANIN
Analog input signal
4
+5V
Voltage speed control signal
reference voltage
5
GND
Voltage speed control signal
reference ground
Pluggable terminal block 5-pin for 0.14~0.15 mm² wire or AWG 28-16 wire
ANOUT : This port converts the real-time speed into an analog voltage signal output in the range
of 0.5-2.9V . The corresponding speed of the motor when the voltage output is 0.5V and 2.9V can