535 User's Manual Table of Contents i
Table of Contents
Table of Contents
PAGE
CHAPTER 1
INTRODUCTION .............................................................................. 1
535 Modes ........................................................................................ 1
Order Code, Packaging Information .................................................. 2
Where To Go Next ............................................................................ 2
Text formatting in this manual............................................................ 2
CHAPTER 2
BASIC INTERFACE ......................................................................... 5
Displays ............................................................................................ 5
Icons (Lit) .......................................................................................... 5
Keys.................................................................................................. 6
Basic Operating Procedures ............................................................. 7
Alarm Operation ................................................................................ 8
CHAPTER 3
INSTALLATION ............................................................................. 11
Mounting the Controller ................................................................... 11
Wiring ............................................................................................. 12
AC Power Input ...................................................................... 13
Process Variable Input ........................................................... 13
Digital Input(s) ........................................................................ 16
1. Digital Inputs with a Switch or Relay ............................... 16
2. Digital Inputs with an Open Collector .............................. 16
Remote Setpoint Option ......................................................... 16
Output Modules ...................................................................... 17
1. Mechanical Relay Output ............................................... 17
2. Solid State Relay (Triac) Output ..................................... 17
3. DC Logic (SSR Drive) Output ......................................... 18
4. Milliamp Output .............................................................. 18
5. Position Proportioning Output ......................................... 18
Serial Communications........................................................... 19
Limit Control ........................................................................... 20
CHAPTER 4
HARDWARE SET UP ..................................................................... 21
Hardware Input Types..................................................................... 21
The Process Variable ...................................................................... 21
The Remote Setpoint ...................................................................... 22
Mechanical Relays .......................................................................... 22
Accessing and changing jumpers.................................................... 23
Adding and Changing output modules ............................................. 24
Special Communications Module .................................................... 26
CHAPTER 5
SOFTWARE CONFIGURATION .................................................... 27
Menus ............................................................................................. 27
Parameters ..................................................................................... 28
Configuration and Operation ........................................................... 29
Where to Go Next............................................................................ 29
About This Manual:
Throughout this User’s Manual
information appears along the
margins (NOTE:, CAUTION! and
WARNING!). Please heed these
safety and good practice notices for
the protection of you and your
equipment.
To Next Page
Loading...