Morbark 20 - Page 16

Performance Adjustment Pages
Operator’s Manual, Morbark Integrated Control System—Model 20 Chipper
16
Introduction
This section covers the different adjustment pages for the Machine. The parameters
contained within those pages will be provided along with a description and the values
each parameter accepts.
Contained within this section:
AutoFeed Settings — Used to modify the performance of the Machine’s feed •
system
Control Select — Used to select the “Control Device” for the Machine•
Note: All modifications discussed
in this section can be reset to
“Factory Defaults” by pressing
the “F2” button from within the
option’s adjustment page.
Note: The “Performance
Adjustment Pages are protected
by a PIN Number to prevent unau-
thorized access. In order to access
these settings:
Navigate to the “Adjust” Sub-
Menu as described on page 25.
Use the “Up/Down” buttons to
navigate to the desired option
(only the “AutoFeed Settings and
“Control Select” options are avail-
able to be modified. All others are
Pre-Set by the OEM).
Press the “OK” button. This will
bring up a dialog box for entry of
the PIN code
Use the “Up/Down” and OK but-
tons to enter the PIN code 0747.
The “OK” button must be pressed
between each digit.
After the last digit is entered press
the “OK” button two(2) times, this
will open the desired adjustment
option.