MoTeC Configuration 29
Bar Graph
The 70 segment bar graph has a user definable range and is typically used as
a tacho, however it can be used to display any other value. When used as a
tacho it may be configured for up to 19000 RPM.
A fully programmable shift point can be displayed, which can also be gear
dependent.
The operation of the bar graph can be different for each of the display modes
(Race, Practice and Warm-up), this allows a lower range to be used in Warm-
up mode.
Numeric Displays
The three numeric displays–left, right and top right–can be programmed to
display any value, which may be different for each of the display modes
(Warm-up, Practice and Race).
Each of the three numeric displays has a different number of digits and is
therefore suited to displaying different values. For example the top right
display can only show values up to a maximum of 199 and is therefore not
suitable for displaying Lap Times, but is suitable for values such as Lap
Number, Fuel Remaining or Engine Temperature.
The numeric displays can show any channel value plus up to two override
values. Override values show each time their value is updated. This is useful
To Next Page
Loading...
