Chapter 15
Charger Reprogramming
Charger reprogramming requires the Communications Interface connected to a computer using a standard
USB cable. The following messages are displayed by the charger when using IMPRES Battery Fleet
Management System to initiate charger reprogramming.
Table 24: Charger Reprogramming Display Options
Charger Display Description
REPROGRAMMING
REMOVE BATTERIES
Remove batteries from the charger pockets before
reprogramming.
REPROGRAMMING
WAITING FOR DATA
All charger pockets are empty.
REPROGRAMMING
Progress yyy%
Reprogramming data is downloading. For chargers
with a display associated with each pocket, the
percentage value is the percentage of data suc-
cessfully downloaded into the pocket associated
with the display. For chargers that have only one
display (Pocket 1), the percentage value is the per-
centage of data successfully downloaded into all
six pockets.
REPROGRAMMING
POCKET#xx FAILED
Reprogramming failed in the identified pocket. The
identified charger pocket starts normal operations
using the previous software.
IMPRES 2
CHARGER
Reprogramming data download is complete. The
charging is completing the Reprogramming proc-
ess.
REPROGRAMMING
COMPLETE
The Reprogramming process completed success-
fully. The charger starts normal operations using
the newly downloaded software. User-defined set-
ting is preserved after charger reprogramming has
been completed.
MN002407A01-AK
Chapter 15: Charger Reprogramming
67
To Next Page
Loading...
