5.8.2.1
Making Phone or PABX Calls
When and where to use:
This feature is only available in Trunked Mode Operation (TMO).
Procedure:
1 From the home screen, enter the number.
2 If Phone or PABX is not the first type of call presented, press Ctype repeatedly to select it.
3 Press the Send key.
4 To end the call, press the End key.
5.8.2.2
Using the Phone/PABX Speed Dial
Procedure:
1 From the home screen, enter the predefined Phone/PABX speed dial number and # key.
2 Press Send key.
5.8.3
Receiving Individual Calls
Procedure:
1 Use one of the following methods to answer a private, phone, or Private Automatic Branch
Exchange (PABX) call.
• Press the PTT button.
• Press the Send key.
2 To end the call, press the End key.
5.9
MS-ISDN
This feature adds to your radio ISDN number. You can choose between MS-ISDN and ISSI to address
the call, send the message or pre-defined templates. It works for both simplex and duplex calls, based
on the assigned ISDN number.
5.10
One-Touch Dial
This feature allows you to call by pressing and holding one of the keys (1-9).
NOTE: If the One-Touch Button feature is disabled, One-Touch Dial is disabled as a
consequence. If no feature is assigned to a button that you press, your radio displays an
Unassigned Button message.
In RMS mode, the One-Touch Button feature is disabled.
5.11
Radio Messaging System (RMS)
NOTE: This is a Software Selling Feature.
MN001489A01-BR
Chapter 5 : Features
139
To Next Page
Loading...
